Alexandrin Garage Doors August 06th, 2018 - 00:51:22
There will be times when your door may fail to operate. It happens from time-to-time no matter how well it is installed and maintained so there is no need to panic. More often that not the battery in your garage remote is dead or it is some other simple garage door repair. It is also a good idea to keep additional power back ups with you such as a manual device (generator UPS etc) or additional batteries. Or you can manually open the garage door until you figure out what the is causing the problem.
In most installations a warning tag is left attached adjacent to the torsion spring when the garage door is installed. This tag warns of the danger associated with the stored energy of this spring and alerts untrained individuals to not attempt any repair adjustment or to even touch the spring and associated hardware. When the label that should be attached to this spring becomes damaged is removed or tampered with it is important that a new warning label be reattached immediately to show the dangers of this spring tension
If you live in the middle of the country then you probably have heard of Delden Garage Doors. Delden is a regional garage door manufacturer and installer that located in middle of the USA with offices in Kansas Nebraska Iowa and Missouri. Delden also owns the Amarr garage door company. Delden has been manufacturing garage doors since the mid 1960s. They manufacture and install a complete line of residential and commercial garage doors. A review of garage door pricing shows that Delden Garage doors are considered a mid priced garage door.
In response to the inherently dangerous old style garage spring issues as above a newer and safer system for opening the overhead garage door was created. The idea was to transfer the load or weight of the door via a cable and pulley system to a vertical rod now equipped with a torsion (twisted) spring. This type of spring is installed with specialty hardware and bolts to a fixed plate at one end while the entire spring is installed around a horizontal pipe. This load balancing device is normally installed directly over the header of the garage opening. Using appropriate cables connectors and pulleys the weight of the garage door is transferred into the torsion spring system. The difference between the old style stretched spring and the newer torsion spring is the way that the spring energy is stored. With the old style stretched spring the energy is stored and released by pulling on the spring or returning the spring to its un-stretched condition.